Now when I test the psu under no load it reports fine but with the 3.3V out of spec reporting over voltage. (with the psu disconnected and hooked up to a psu tester that is.
Got up to 160W load on it and still can not get the voltage to read out of spec. Perhaps there was a short or something that was corrected by swapping out the psu's...
1.2 Kw pc power and cooling. It has a 7 year warranty so if I can find an actual issue with it I can get it replaced no problem.
I swapped it out with a 750W pc power and cooling silencer and then increased the stagger start up rate for my HDDs to prevent too much strain on the smaller unit.